1 canale Relè Modulo 5V scheda di espansione per Arduino PIC AVR DSP ARM high level trigger

Product Description

1 canale Modulo 5V scheda di espansione per Arduino PIC AVR DSP ARM high level trigger

Questi moduli a 1 canale possono essere utilizzati per controllare qualsiasi carico vogliate che siano lampade, sirene o altre apparecchiature.

Il design modulare rende facile l’espansione con la scheda Arduino, sono perfettamente compatibili e controllabili con qualsiasi microcontrollore MCU, PIC, ARM, AVR e MSP430.
Lo stato dell’uscita, se attiva o no, segnalata dall’accensione di un led corrispondente ad ogni singolo

Specifiche tecniche:
Corrente di eccitazione necessaria: 15-20mA ogni singolo canale
Segnale di controllo: 5Vcc livello TTL
Tensione di commutazione massima: 250VAC, 30VDC
Equipaggiati con ad alta corrente SPDT: 30Vcc 10A – 250Vca 10A
Strip connessione: 2.54mm

High-level triggered will allow the current to go through the power line when the control signal is above a certain voltage.

Product description:

1, the module complies with international safety standards, control area load area isolation groove;

2, genuine relay Songle;

3, with the power and relay action instructions, pull bright disconnect does not shine;

4, when a signal in the signal input terminal, the common terminal and the normally start conduction;

5, microcontroller development board can be used as a module that can be used as a home appliance control;

6, the control of the DC or AC signal, can control 220V AC load;

7, there is a normally open and a normally closed contact;

8, blue KF301 terminals to the line of control is more convenient.

Description of the high and low trigger, friends do not understand Take a look at:

High level trigger is a trigger voltage between the signal input and ground can be understood as a way of the signal input terminal and VCC cathode short trigger;

Low trigger means is the voltage between the signal input terminal and the ground for the OV trigger mode can be understood as a way of the signal input terminal and GND negative short trigger
1 relay module wiring

• LED indicator light for power on and contacting status indication
• Output terminals are the three screw terminals with blue plastic casing: the terminal in the middle for Com. the left one for NO,the right one for NC
• It can be used as a relay module for various logic control units
• Low level triggering means that when the voltage between the input terminal(IN) and ground(GND) is 0, the relay will be activated.

size: 43x17x18.5mm

Abbiamo disponibili datasheet di tutti i componenti, qualora non fosse presente nella scheda download del prodotto inviaci un messaggio dal modulo contattaci e lo pubblicheremo il prima possibile nel nostro sito.